Filament Dryer Box Pro - Controller & Telemetry

🔥

Chamber Temperature

Target: 50.0 °C

24.5 °C

Set: 50.0 °C

💧

Relative Humidity

Target: <15.0%

48.2 %RH

Target: <15.0%

⏱️

Active Process Status

STANDBY

06:00:00

Elapsed: 00:00:00 Total Duration: 06:00:00

Autonomous Hardware Execution: If this app is disconnected or closed, your nRF52840 boards continue the drying cycle uninterrupted.

🧵

Filament Drying Profiles

Select an optimized drying preset or craft your custom temperature, humidity, and duration setpoints.

📈

Live Telemetry & Duty Cycle

Duty: 0%

Temp (°C) Humidity (%) Target Temp Relay ON

💻

Hardware Monitor & Serial Terminal

[SYS] Filament Dryer Pro App initialized. Ready to connect.

[INFO] Sensor Board: (I2C HDC1080 + SH1106 OLED)

[INFO] Relay Board: (P0.29 AC Relay + Watchdog)

[HINT] Click 'Connect BLE' or 'USB Serial' to stream live telemetry.

Board	Function	Pin	Notes
Sensor Board	I2C SDA / SCL	P0.15 / P0.13	HDC Sensor (0x40) & OLED (0x3c)
Sensor Board	Status LED	P0.22 (Green)	1Hz heartbeat blink
Relay Board	Heater Relay	P0.29	Active HIGH (Relay Driver / SSR)
Relay Board	Heating LED	P1.09 (Red)	Active LOW, ON when relay energized
Relay Board	Power LED	P0.22 (Green)	Active LOW, Power / Standby

Neorobotics Auth Gate

KVKK ve Onay Gerekli

Filament Dryer Pro

Chamber Temperature

Relative Humidity

Active Process Status

Filament Drying Profiles

Custom Drying Profile Configuration

Live Telemetry & Duty Cycle

Hardware Monitor & Serial Terminal

Neorobotics Auth Gate

Filament Dryer Pro

KVKK ve Onay Gerekli

Chamber Temperature

Relative Humidity

Active Process Status

Filament Drying Profiles

Custom Drying Profile Configuration

Live Telemetry & Duty Cycle

Hardware Monitor & Serial Terminal

Firmware Build & Flashing Guide

Compiling & Flashing Sensor Board

Compiling & Flashing Relay Board

Hardware Pinout Reference